8th Floor, L&C Annex, 401 Church Street
Nashville, TN 37243-1551
1-800-734-3619 or email: firstname.lastname@example.org
TDEC's Self Disclosure Policy
Sample Request for Monetary Penalty Waiver
Compliance Advisory Panel
Emerg. Planning & Community Right to Know Act
Energy conservation and efficiency
Hazardous Air Pollutants list
Risk Mgt. Program - Clean Air Act Section 112(r)
Spill Prevention Control & Countermeasures Plan
NESHAP (MACT) standards by affected source category
Hot Mix Asphalt Plants
Processing and Roofing Products Manufacturing
Al, Cu, and Nonferrous Foundries
Ferroalloy Production Facilities
Metal Fabrication and Finishing
Plating and Polishing Paint
Paints and Allied Products Manufacturing
Surface Coating and Paint Stripping
Ready Mix Concrete
Reinforced Plastic Composites
Retail Gasoline Marketers
Risk Management Program
Storm Water Management
Construction: NPDES permit brochure
ECOS: Small Communities
On this page you will find information from the Small Business Environmental Assistance Program including notices of new proposed or promulgated regulations affecting small businesses, training opportunities, small business highlights and other items of interest to small businesses.
October 24, 2012
On September 19, 2012, the EPA published amendments to the NESHAP for Hard and Decorative Chromium Electroplating and Chromium Anodizing Tanks (40 CFR 63 Subpart N). Changes were made in several areas including emission limits, monitoring standards, recordkeeping, and reporting. For more information and a fact sheet outlining the changes, see the Chromium Electroplating page.
October 4, 2012
Facilities subject to the Chemical Manufacturing rule (40 CFR 63 Subpart 6V) are required to submit a Notification of Compliance Status by October 29, 2012. More information can be found on SBEAP’s Chemical Manufacturing page.
March 27, 2012
The EPA issued a No Action Assurance Letter (NAA) to establish that they will exercise enforcement discretion to not pursue enforcement action for violations of the initial tune-up deadlines in the final Area Source Boiler rule. The EPA intends to issue the final reconsideration rule prior to any of the compliance dates for existing sources. For details, please see the Area Source NAA Letter.
December 15, 2011
Reconsideration Proposal for Boilers at Area Sources, Boilers/Process Heaters at Major Sources, Commercial/Industrial Solid Waste Incinerators and Proposed Definition of "Non-Hazardous Solid Waste"
See SBEAP Boiler page for information on the current rule affecting boilers.
February 9, 2012
**NEW Gasoline Distribution NESHAP 6C Video from EPA**
EPA has developed an informational video describing “Stage I" gasoline storage tank filling control requirements resulting from the Federal Gasoline Distribution Facility rule as part of their Air Pollution Training Institute. The video explains what a NESHAP is, why it exists, the general requirements of the 6C rule and which specific businesses are affected. The video is available for viewing online at the EPA APTI Website.