Department of Labor and Workforce Development
Karla Davis, Commissioner

No fall protection for unprotected sides and edges above 6 feet    

No covers on holes, including skylights, on walking/working surfaces

No fall protection for employees working on low-slope roofs above 6 feet

No fall protection while working on steep roof above 6 feet

Scaffold platforms not fully planked or decked

Ties, guys, braces, or outriggers not used to prevent tipping of scaffolds

Poles, legs, posts, frames and uprights of scaffold did not bear on base plates and mud sills

Scaffolds not properly crossbraced

Front-end loaders, etc., used to support scaffolds

Ladder not provided to access scaffold

Scaffold not inspected by competent person before each workshift

Scaffold not erected, dismantled, moved, etc., under supervision of a competent person

No fall protection on scaffolds 10 feet or higher

Inadequate guardrails on open sides and ends of scaffold platforms

Ladder side rails do not extend 3 feet above upper surface

Ladders used for purpose other than for which they were designed

Unsecured ladders placed in passageways, doorways, driveways, etc.

Top or top step of ladder used as a step

No training on fall hazards for exposed employees

Ground-fault-circuit interrupters not provided on electrical outlets

No permanent and continuous electrical path to ground

Body belt not worn, nor lanyard attached to the boom or basket, when working from an aerial lift

Workers not standing firmly on the floor of the basket

More than 25 feet of lateral travel between safe means of egress from trench excavations

Materials or equipment within 2 feet of the edge of excavation

No daily inspection of excavation by a competent person

No protective helmets worn where there is danger of head injuries

Flexible cords and cables not protected from damage

Strain relief not provided on flexible cords

Unused openings in cabinets, boxes or fittings not effectively closed and conductors entering boxes, cabinets, etc., not protected from abrasion

Inadequate cave-in protection on excavation site

Employees not instructed in recognizing & avoiding unsafe conditions

Employees working on scaffolds not trained

Electric equipment not installed and used according to listing, labeling, or certification

No one trained to render first aid

Fabricated frame scaffolds not properly crossbraced

No fall protection for unprotected sides and edges above 15 feet for employees engaged in steel erection
activity

Worn or frayed electric cords/cables used

PPE not provided, used, and maintained in a sanitary and reliable condition

Protruding reinforcing steel onto which employees could fall not guarded

Employees engaged in steel erection activity not trained on fall hazards